System Operators, Wiki Staff
833
edits
m (→Consuming) |
|||
(2 intermediate revisions by the same user not shown) | |||
Line 21: | Line 21: | ||
#At points 1 and 2 set these pumps both to on and max output pressure (4500kpa) | #At points 1 and 2 set these pumps both to on and max output pressure (4500kpa) | ||
#At point 3 set the air alarm scrubber controls to "Mode: '''Siphoning'''" and "Range: '''Expanded'''" | #At point 3 set the air alarm scrubber controls to "Mode: '''Siphoning'''" and "Range: '''Expanded'''" | ||
#At point 3 set the air alarm vent controls to "'''Internal''' Target Pressure: 0 Kpa" | #At point 3 set the air alarm vent controls to "'''Internal''' Target Pressure: 0 Kpa", while disabling '''External''' | ||
#At point 4 turn the pump off ''You don't want the coolant gas to bypass the SM do you?'' | #At point 4 turn the pump off ''You don't want the coolant gas to bypass the SM do you?'' | ||
#At point 5 turn the filter on, set it to max output pressure (4500kpa) and set it to filter nothing | #At point 5 turn the filter on, set it to max output pressure (4500kpa) and set it to filter nothing | ||
Line 30: | Line 30: | ||
#At point 13 wrench the two N2 canisters | #At point 13 wrench the two N2 canisters | ||
#At point 13 turn both of the pumps on and set them to max output pressure (4500kpa) | #At point 13 turn both of the pumps on and set them to max output pressure (4500kpa) | ||
#Finally, ensure that gas is flowing through the system via gas flow meters, if not double check all steps or where there is build up. | |||
====Step 3: Plasma==== | ====Step 3: Plasma==== |