7
edits
Guide to Atmospherics: Difference between revisions
Jump to navigation
Jump to search
no edit summary
m (Hexane updated with recipe (corrected the ration and added the consumption rate of Hydrogen)) |
No edit summary |
||
| Line 133: | Line 133: | ||
===[[File:Vent.webp|frameless]]Unary Vent=== | ===[[File:Vent.webp|frameless]]Unary Vent=== | ||
The vent will pump gas into the room it is in, depending on the air alarm settings of the room. The air alarm has two settings to worry about, External, or Internal. External works by making the vent pump gas from its connected pipenet into the room until the room, or more accurately, the tile, matches the pressure that is set. The max pressure you can configure for External is 5066 kPa, and it slows down when approaching the set limit, as pressure pumps do. Internal works by pumping gas into the room from the pipenet until the pressure set matches the pressure in the connected pipenet. Examples: a vent set to External 200 will pump gas into the room until it is 200 kPa. A vent set to Internal 300 will pump gas into the room until the connected pipenet's pressure is 300 kPa, regardless of room pressure. As such, Internal 0 will always pump at full strength. This same effect can be achieved by turning off both External and Internal. The vent has a maximum speed it can pump at, even when extremely pressurised. | The vent will pump gas into the room it is in, depending on the air alarm settings of the room. The air alarm has two settings to worry about, External, or Internal. External works by making the vent pump gas from its connected pipenet into the room until the room, or more accurately, the tile, matches the pressure that is set. The max pressure you can configure for External is 5066 kPa, and it slows down when approaching the set limit, as pressure pumps do. Internal works by pumping gas into the room from the pipenet until the pressure set matches the pressure in the connected pipenet. Examples: a vent set to External 200 will pump gas into the room until it is 200 kPa. A vent set to Internal 300 will pump gas into the room until the connected pipenet's pressure is 300 kPa, regardless of room pressure. As such, Internal 0 will always pump at full strength. This same effect can be achieved by turning off both External and Internal. The vent has a maximum speed it can pump at, even when extremely pressurised. | ||
===[[File:Ventpassive.webp|frameless]]Passive Vent=== | |||
An unpowered vent that equalizes the internal and external gases, think of it as a simple open-ended pipe into the atmosphere. It is not interactable and cannot be closed. It too, is not restricted by pressure as with the other vents, opening possibilities for interesting shenanigans. | |||
===[[File:Injector atmos.webp|frameless]]Injector=== | ===[[File:Injector atmos.webp|frameless]]Injector=== | ||
The injector is similar to the vent in that it pumps gas onto the tile it is on. However, it is not controlled by an air alarm, but rather works by hand. It is also in L/s units again, similarly to the volume pump. Also similarly to the volume pump, it is the faster one when compared to its pressure based cousin, the vent. It does not have a maximum pressure change per second, as vents do, and will always outpace them. This comes at the cost of the control that vents give you. | The injector is similar to the vent in that it pumps gas onto the tile it is on. However, it is not controlled by an air alarm, but rather works by hand. It is also in L/s units again, similarly to the volume pump. Also similarly to the volume pump, it is the faster one when compared to its pressure based cousin, the vent. It does not have a maximum pressure change per second, as vents do, and will always outpace them. This comes at the cost of the control that vents give you. | ||