Guide to toxins: Difference between revisions

While this method produces very hot gas, the gas is (mostly) [[CO2]]. In order to make a bomb you will require heated [[Plasma]], this can be achieved by pumping this gas into a tank that already contains plasma to heat it up as described below, but a larger explosion is possible if you have a hot tank of pure plasma without mixing in any CO2. Other methods are possible, have fun experimenting and try not to destroy the station too many times.

  |bgcolor1 = #cce6ff

  |bgcolor2 = #99ccff

Now you'll want to start off by dispensing one or two [[Plasma Tank]]s from the [[Tank Storage Unit]], load into the white [[Portable Scrubber]], making sure it's pressure is set to 1013 kPa, and get rid of all that plasma. Then take the Plasma Tanks to a Plasma Canister and put a small amount of plasma in the tank, setting the pressure to 50 kPa will work, but experiment with different amounts to change the size of the explosion. Once this is done go and slot them into one of your yellow Canisters, making sure that the output pressure is at 1013 kPa. This should result in a high pressure, high temperature tank of (mostly) plasma.

  |bgcolor1 = #cce6ff

  |bgcolor2 = #99ccff

  |image = Plasma_tank.png

  }}

  |bgcolor1 = #cce6ff

  |bgcolor2 = #99ccff

Now take these tanks of heated gas and attach each one to a [[Tank Transfer Valve]], once you've done that it's back to the dispenser.

This time get an equal amount of [[Oxygen Tank]]s from the [[Tank Storage Unit]] and fill them with oxygen from the Oxygen [[Canister]] you got at the start of this section, again make sure the pressure is set to 1013 kPa. Now attach each to a Tank Transfer Valve that already has a Plasma Tank on and you'll have a bomb, or several.

  |bgcolor1 = #ccccee

  |bgcolor2 = #ddddff

From here on you have 5 options, [[Timer]]s, [[Proximity Sensor]]s, [[Remote Signaling Device]]s, [[Voice Analyzer]]s, or [[Infrared Emitter]]s. Each of these is a method of setting off your bomb, for your first bomb you should use a Remote Signaling Device. To attach these devices to a [[Tank Transfer Valve]] you need to use a screwdriver on them till they are ready for attachment. Grab a Remote Signaling Device click it to set a frequency of your choice, then use it on the Tank Transfer Valve to attach it, all done, you have a bomb, ready for use.

  |bgcolor1 = #FFEE88

  |bgcolor2 = #FFDD66

  |image = Timer.png

  }}

  |bgcolor1 = #FFEE88

  |bgcolor2 = #FFDD66

  |image = Prox Sensor.png

  }}

  |bgcolor1 = #FFEE88

  |bgcolor2 = #FFDD66

  |image = Signaler.png

  }}

  |bgcolor1 = #FFEE88

  |bgcolor2 = #FFDD66

  |image = Voice_Analyzer.png

  }}

  |bgcolor1 = #FFEE88

  |bgcolor2 = #FFDD66